Chamberlain 211X User Manual download pdf (Page 26)

Security✚

3-Channel Remote Control Programming (Optional)

The 900 Series remote control works only with door

openers and light controls having an orange "Learn"

button.

Programming instructions are described and illustrated

below. The additional push buttons can also activate

other garage door openers and/or light controls.

(Instructions for programming light products are

included with those accessories.)

To prevent possible SERIOUS INJURY or DEATH from a

moving gate or garage door:

• ALWAYS keep remote controls out of reach of children.

NEVER permit children to operate, or play with remote

control transmitters.

• Activate gate or door ONLY when it can be seen clearly, is

properly adjusted, and there are no obstructions to door

travel.

• ALWAYS keep gate or garage door in sight until

completely closed. NEVER permit anyone to cross path of

moving gate or door.

WARNING

CAUTION

WARNING

Open/Close/Stop Operation

Your Security✚

remote control can be programmed to

operate one door using all 3 buttons: the large button

will only open the door, the middle button will close the

door and third button will stop the door’s movement.

You may set up this feature as follows:

1. With the door closed, press and

hold the large remote push

button.

2. Press and hold the Lock button

on the door control.

3. Press and hold the door control

push bar.

When the opener lights flash, release all buttons. Test

by pressing the large (Open) button on the remote. The

door should open. Press it again while the door is open

and nothing should happen. Press the middle (Close )

button and the door should close. Press the third

(Stop) button while the door is moving and it should

stop immediately.

The Remote Control Batteries

The lithium batteries should produce

power for up to 5 years. To replace,

pry open case with visor clip or

screwdriver, as shown. Insert batteries

positive side up (+).

Dispose of old batteries properly.

To prevent possible SERIOUS INJURY or DEATH:

• NEVER allow small children near batteries.

• If battery is swallowed, immediately notify doctor.

WARNING

CAUTION

WARNING

PROGRAMMING

NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or

modifications of this receiver and/or transmitter are prohibited, except for changing the

code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Instructions are Described and

Illustrated Below

1. Press and release the “learn”

button on the motor unit. The learn

indicator light will glow steadily for

30 seconds.

2. Within 30 seconds, press and hold

the button on the hand-held

remote.

3. Release the button when the motor

unit light blinks. It has learned the

code. If light bulbs are not

installed, two clicks will be heard.

To Erase All Codes From Motor Unit Memory

To deactivate any unwanted remote, first erase all

codes:

Press and the hold “learn” button on motor unit until the

learn indicator light goes out (approximately 6 seconds).

All previous codes are now erased. Reprogram each

remote or keyless entry you wish to use.

To Control the Opener Lights

With Security✚

transmitters, a remote push button can

be programmed to operate the opener lights without

opening the door.

1. With the door closed, press and hold the remote

button that you want to control the light.

2. Press and hold the Light button on the door control.

3. Press and hold the Lock button on the door control.

4. After the opener lights flash, release all buttons.

Test by pressing the remote push button. The opener

lights should turn on or off but the door should not

move.

Open

Stop

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

Comments to this Manuals

No comments

Chamberlain 211X User Manual Page 26

Comments to this Manuals

Related products and manuals for Garage Door Opener Chamberlain 211X