Chamberlain LIFTMASTER 3265CM User Manual download pdf (Page 19)

Fiberglass, aluminum or lightweight steel garage doors WILL

REQUIRE reinforcement BEFORE installation of door bracket.

Contact your door manufacturer for reinforcement kit.

INSTALLATION STEP 11

Fasten the Door Bracket

Follow instructions which apply to your door type as

illustrated below or on the following page.

A horizontal reinforcement brace should be long

enough to be secured to two or three vertical

supports. A vertical reinforcement brace should cover

the height of the top panel.

Figure 1 shows one piece of angle iron as the horizontal

brace. For the vertical brace, 2 pieces of angle iron are

used to create a U-shaped support. The best solution is to

check with your garage door manufacturer for an opener

installation door reinforcement kit.

NOTE: Many door reinforcement kits provide for direct

attachment of the clevis pin and door arm. In this case you

will not need the door bracket; proceed to Step 12.

SECTIONAL DOORS

1. Center the door bracket on the previously marked

vertical centerline used for the header bracket

installation. Note correct UP placement, as stamped

inside the bracket.

2. Position the top edge of the bracket 2"-4" (5-10 cm)

below the top edge of the door, OR directly below any

structural support across the top of the door.

3. Mark, drill holes and install as follows, depending on

your door’s construction:

Metal or light weight doors using a vertical angle iron

brace between the door panel support and the door

bracket:

• Drill 3/16" fastening holes. Secure the door bracket

using the two 1/4"-14x5/8" self-threading screws.

(Figure 2A)

• Alternately, use two 5/16" bolts, lock washers and nuts

(not provided). (Figure 2B)

Metal, insulated or light weight factory reinforced

doors:

• Drill 3/16" fastening holes. Secure the door bracket

using the self-threading screws. (Figure 3)

Wood Doors:

• Use top and bottom or side to side door bracket holes.

Drill 5/16" holes through the door and secure bracket

with 5/16"x2" carriage bolts, lock washers and nuts (not

provided). (Figure 4)

NOTE: The 1/4"-14x5/8" self-threading screws are not

intended for use on wood doors.

Vertical

Centerline

of Garage

Door

Bracket

Location

Header

Bracket

HORIZONTAL AND VERTICAL

REINFORCEMENT IS NEEDED

FOR LIGHTWEIGHT GARAGE

DOORS (FIBERGLASS,

ALUMINUM, STEEL, DOORS

WITH GLASS PANEL, ETC.).

(NOT PROVIDED)

Door

Bracket

Vertical

Centerline

of Garage Door

Vertical

Reinforcement

Self-Threading

Screw

1/4"-14x5/8"

Self-Threading

Screw

1/4"-14x5/8"

Door

Bracket

Nut

5/16"-18

Bolt

5/16"-18x2"

Lock Washer

5/16"

Vertical

Reinforcement

(Not Provided)

Vertical

Centerline

of Garage Door

Self-Threading

Screw

1/4"-14x5/8"

Vertical

Centerline

of Garage Door

Inside Edge

of Door or

Reinforcement Board

Bolt

5/16"x2"

(Not Provided)

Vertical

Centerline

of Garage

Door

Figure 1

Figure 2A

Figure 3

Figure 4

Figure 2B

HARDWARE

SHOWN

ACTUAL SIZE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Comments to this Manuals

No comments

Chamberlain LIFTMASTER 3265CM User Manual Page 19

Comments to this Manuals

Related products and manuals for Garage Door Opener Chamberlain LIFTMASTER 3265CM