Chamberlain WD832KEV User Manual download pdf (Page 33)

Operation

Features

Your garage door opener is equipped with features to provide you with greater control over your garage

door operation.

MyQ

technology usesa 900MHz signal to provide two-way communication between the garage door

opener and MyQ

enabled accessories.Your garage door opener is compatible with up to 8 MyQ

accessories.For Smartphone App control of your garage door opener and other MyQ

accessories,

Chamberlain's MyQ

Internet Gateway(model CIGBU) is required.

Alert2Close

The Alert2Close feature provides a visual and an audible alert that an unattended door is closing.

TIMER-TO-CLOSE (TTC)

The Timer-to-Close feature automaticallyclosesthe garage door after a specified time period. DO NOT

enable TTC if operating a one-piece door. TTC is to be used ONLY with sectional doors. Factory

default is set to off. The garage door opener will beep and the lights will flash before closing the door.

The TTC feature will deactivate if the garage door encounters an obstruction twice;or the safetyreversing

sensors are incorrectly installed.The garage door will reverse open and WILL NOT close until the

obstructions are clear or the safety reversing sensors are correctly installed.When the obstruction has

been cleared or the safetyreversing sensors have been aligned, the door will close when the garage

door opener is activated. TTC WILL NOT work ifthe garage door opener is operating bybattery power or

if the safetyreversing sensors are misaligned. This feature is NOT intended to be the primary method of

closing the door. A keyless entry should be installed in the event of an accidental lock out when

using this feature.

REMOTE CONTROLS AND DOOR CONTROLS (MyQ

)

Your garage door opener hasalreadybeen programmed at the factory to operate with your remote

control,which changes with each use,randomly accessing over 100 billion new codes.Compatible with

MyQ

enabled accessories,see page 40.

NOTE: Older Chamberlain remote controls, door controls, and third party products are not compatible.

MyQ

Accessories MEMORY CAPACITY

Remote Controls Up to 8

Door Controls Up to 2 MyQ

door controls

KeylessEntries Up to 1

THE PROTECTOR SYSTEM

(SAFETY REVERSING SENSORS)

When properly connected and aligned,the safetyreversing sensorswill detect an obstruction in the path

of the infrared beam.If an obstruction breaksthe infrared beam while the door is closing, the door will

stop and reverse to full open position,and the opener lights will flash 10 times. Ifthe door is fully open,

and the safety reversing sensors are notinstalled,or are misaligned, the door will notclose from a

remote control. However,you can close the door if you hold the button on the door control or keyless

entry until the door is fully closed. The safetyreversing sensors do noteffect the opening cycle.

ENERGY CONSERVATION

For energyefficiency the garage door opener will enter sleep mode when the door is fully closed. The

sleep mode shuts the garage door opener down until activated.The sleep mode is sequenced with the

garage door opener light bulb; as the light bulb turnsoff the sensor LEDs will turn off and whenever the

garage door opener lightsturn on the sensor LEDs will light. The garage door opener will not go into the

sleep mode until the garage door opener hascompleted 5 cycles upon power up.

LIGHTS

The garage door opener lightbulbs will turn on when the opener isinitially plugged in; power isrestored

after interruption, or when the garage door opener is activated. The lightswill turn offautomaticallyafter

4-1/2 minutes.An incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiency a

26W (100W equivalent) compactfluorescent light(CFL) bulb may be used. NOTE: Do not use halogen,

short neck, or specialty light bulbs as these may overheat the end panel or light socket. Do not use LED

bulbs as they may reduce the range or performance of your remote controls.

NOTE: Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or

light socket. Do not use LED bulbs as they may reduce the range or performance of your remote controls.

Light Feature

The garage door opener is equipped with an added feature;the lights will turn on when someone enters

through the open garage door and the safetyreversing sensor infrared beam is broken. For added

control over the light bulbs on your garage door opener, see page 33.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comments to this Manuals

No comments

Chamberlain WD832KEV User Manual Page 33

Comments to this Manuals

Related products and manuals for Garage Door Opener Chamberlain WD832KEV