Chamberlain 248739 User Manual download pdf (Page 18)

INSTALLATION STEP 7

Install the Lights

• Press the release tabs on both sides of lens. Gently

rotate lens back and downward until the lens hinge is in

the fully open position. Do not remove the lens.

• Install a 100 watt maximum light bulb in each socket.

Light bulb size should be A19, standard neck only.

The lights will turn ON and remain lit for approximately

4-1/2 minutes when power is connected. Then the

lights will turn OFF.

• Reverse the procedure to close the lens.

• Use A19, standard neck garage door opener bulbs for

replacement.

NOTE: Use only standard light bulbs. The use of short neck

or speciality light bulbs may overheat the endpanel or light

socket.

To prevent possible OVERHEATING of the endpanel or

light socket:

• DO NOT use short neck or specialty light bulbs.

• DO NOT use halogen bulbs. Use ONLY

incandescent.

To prevent damage to the opener:

• DO NOT use bulbs larger than 100W.

• ONLY use A19 size bulbs.

To prevent possible SERIOUS INJURY or DEATH from a

falling garage door:

• If possible, use emergency release handle to

disengage trolley ONLY when garage door is

CLOSED. Weak or broken springs or unbalanced

door could result in an open door falling rapidly and/

or unexpectedly.

• NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

• NEVER use handle to pull door open or closed. If

rope knot becomes untied, you could fall.

INSTALLATION STEP 8

Attach the Emergency Release Rope

and Handle

• Thread one end of the rope through the hole in the top

of the red handle so “NOTICE” reads right side up as

shown. Secure with an overhand knot at least

1" (2.5 cm) from the end of the rope to prevent

slipping.

• Thread the other end of the rope through the hole in the

release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet (1.8 m) above

the ﬂ oor. Ensure that the rope and handle clear the tops

of all vehicles to avoid entanglement. Secure with an

overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut

end with a match or lighter to prevent unraveling.

100 Watt (Max)

Standard Light Bulb

100 Watt (Max)

Standard Light Bulb

Lens

Hinge

Release Tab

Trolley

Release Arm

Overhand

Knot

Emergency

Release Handle

Trolley

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comments to this Manuals

No comments

Chamberlain 248739 User Manual Page 18

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain 248739