36
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control,remote control,wireless
keyless entry or MyQ
®
accessory.
When the door is closed and the garage door opener isactivated the door will open. Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door is in anyposition other
than closed and the garage door opener isactivated the door will close. If the garage door opener
sensesan obstruction while closing, the door will reverse.If the obstruction interrupts the sensor beam
the garage door opener lightswill blink 10 times.However,you can close the door if you hold the button
on the door control or keylessentry until the door is fully closed. The safetyreversing sensorsdo not
affectthe opening cycle.
The safetyreversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
Using the Motion Detecting Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, pressthe push bar until the garage door
opener activates(it maytake up to 3 presses). Test the door control by pressing the push bar, each press
of the push bar will activate the garage door opener.
ON (TTC)
OFF (TTC)
Command LED
Motion Sensor
Switch
LIGHT
Button
HOLD OPEN
Button(TTC)
Motion
Sensor
Push Bar
1, 5, and
10 Minute
TTC LED
LEARN Button
LOCK Button
MOTION DETECTING CONTROL PANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHT button to turn the garage door opener lights on or off.When the lights are turned on
they will stay on until the LIGHTbutton is pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lights will turn offafter the specified period oftime (the
factory setting is 4-1/2 minutes). The LIGHTbutton will not control the lights when the door is in motion.
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button (approximately10 seconds) until the garage door opener lightsflash.
The time interval is indicated by the number times the garage door opener flashes:
l
1 flash is 1-1/2 minutes
l
2 flashes is 2-1/2 minutes
l
3 flashes is 3-1/2 minutes
l
4 flashes is 4-1/2 minutes
To cycle through the time intervals repeatthe step above.
Light Feature
The lights will turn on when someone enters through the open garage door and the safetyreversing
sensor infrared beam is broken.
l
Deactivate: Press and hold the LIGHTbutton (approximately10 seconds) until the garage door
opener lightsturn on, then off again.
l
Activate: Start with the garage door opener lights on.Press and hold the LIGHT button
(approximately 10 seconds) until the garage door opener lights turn off, then on again.
If the command LED is continuously blinking, the LOCK feature needs to be deactivated.
(16 pages)
(4 pages)
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals