Chamberlain HD950WF Instruction Manual download pdf (Page 21)

Installation

STEP 11 Wire the door control to the garage door opener

HARDWARE

Ins

ulated Staple

(Not Shown)

1. Run the white and red/white wire from the door control to the garage door opener. Attach the

wire to the wall and ceiling with the staple (not applicable for gang box or pre-wired installations).

Do not pierce the wire with the staple as this may cause a short or an open circuit.

2. Strip 7/16 inch (11 mm) ofinsulation from the end of the wire near the garage door opener.

3. Connectthe wire to the red and white terminals on the garage door opener. If your garage is pre-

wired make sure you use the same wires that are connected to the door control. To insert or

release wires from the terminal, push in the tab with screwdriver tip.

RED

WHITE

GREY

7/16" (11 mm)

Staple

STEP 12 Attach the warning labels

1. Attach the entrapment warning label on the wall near the door control with tacksor staples.

2. Attach the manual release/safetyreverse testlabel in a visible location on the inside of the

garage door.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

No comments

Chamberlain HD950WF Instruction Manual Page 21