Chamberlain LIFTMASTER 3265CM User Manual download pdf (Page 32)

1. Enter a four digit personal

identification number (PIN) of your

choice on the keypad. Then press

and hold ENTER.

2. While holding the ENTER button,

press and hold the LIGHT button on

the Multi-Function Door Control.

3. Continue holding the ENTER and

LIGHT buttons while you press the

push bar on the Multi-Function Door

Control (all three buttons are held).

4. Release buttons when the motor unit

lights blink. It has learned the code. If

light bulbs are not installed, two clicks

will be heard.

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.

USING THE “LEARN” BUTTON USING THE MULTI-FUNCTION DOOR CONTROL

NOTE: This method requires two people if the Keyless Entry

is already mounted outside the garage.

LIGHT

To change an existing, known PIN

If the existing PIN is known, it may be changed by one

person without using a ladder.

1. Press the four buttons for the present PIN, then press and

hold the # button.

The opener light will blink twice. Release the # button.

2. Press the new 4-digit PIN you have chosen, then

press Enter.

The motor unit lights will blink once when the PIN has been

learned.

Test by pressing the new PIN, then press Enter. The door

should move.

To set a temporary PIN

You may authorize access by visitors or service people with a

temporary 4-digit PIN. After a programmed number of hours

or number of accesses, this temporary PIN expires and will

no longer open the door. It can be used to close the door

even after it has expired. To set a temporary PIN:

1. Press the four buttons for your personal entry PIN (not the

last temporary PIN), then press and hold the ✽ button.

The opener light will blink three times. Release the button.

2. Press the temporary 4-digit PIN you have chosen, then

press Enter.

The opener light will blink four times.

3. To set the number of hours this temporary PIN will work,

press the number of hours (up to 255), then press ✽.

3. To set the number of times this temporary PIN will work,

press the number of times (up to 255), then press #.

The opener light will blink once when the temporary PIN has

been learned.

Test by pressing the four buttons for the temporary PIN, then

press Enter. The door should move. If the temporary PIN was

set to a certain number of openings, remember that the test

has used up one opening.To clear the temporary password,

repeat steps 1-3, setting the number of hours or times to 0 in

step 3.

One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been

activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1

and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times

when one button close is deactivated.

1. Press and release the “learn” button

on motor unit. The learn indicator light

will glow steadily for 30 seconds.

2. Within 30 seconds, enter a four digit

personal identification number (PIN) of

your choice on the keypad. Then

press and hold the ENTER button.

3. Release the button when the motor

unit lights blink. It has learned the

code. If light bulbs are not installed,

two clicks will be heard.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Comments to this Manuals

No comments

Chamberlain LIFTMASTER 3265CM User Manual Page 32

Comments to this Manuals

Related products and manuals for Garage Door Opener Chamberlain LIFTMASTER 3265CM