Chamberlain WD962KLD User Manual download pdf (Page 22)

MOUNTING AND WIRING THE SAFETY

REVERSING SENSORS

Mounting:

• Slide a 1/4"-20x1/2" carriage bolt head into the slot

on each sensor. Use wing nuts to fasten sensors

to brackets, with lenses pointing toward each other

across the door. Be sure the lens is not obstructed by a

bracket extension (Figure 5).

• Finger tighten the wing nuts.

Option A - Installation Without Pre-Wiring:

• Run the bell wire from both sensors to the garage

door opener. Attach the wire to the wall and ceiling

with the staples (Figure 6).

Option B - Pre-Wired Installation:

If your garage already has wires installed for the safety

reversing sensors, follow the instructions below:

• Cut the end of the safety sensor wire, making sure there

is enough wire to reach the pre-installed wires from the

wall (Figure 7).

• Separate the safety sensor wires and strip 7/16 inch

(11 mm) of insulation from each end. Choose two of

the pre-installed wires and strip 7/16 inch (11 mm) of

insulation from each end. Make sure that you choose

the same color pre-installed wires for each sensor

(Figure 8).

• Connect the pre-installed wires to the sensor wires with

wire nuts making sure the colors correspond for each

sensor (Figure 9).

Figure 5

Figure 6

Figure 7

Figure 9

Figure 8

Safety Reversing

Sensor Wires

Safety Reversing

Sensor Wires

White

White/Black

Not Provided

Pre-installed

wires

Carriage Bolt

1/4"-20x1/2"

Wing Nut

Lens

Pre-Installed Wires

7/16"

(11mm)

7/16"

(11mm)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Comments to this Manuals

No comments

Chamberlain WD962KLD User Manual Page 22

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain WD962KLD