Chamberlain WD962KLD User Manual download pdf (Page 32)

Using Your Garage Door Opener

Your Security✚

opener and hand-held remote control

have been factory-set to a matching code which changes

with each use, randomly accessing over 100 billion

new codes. Your opener will operate with up to eight

Security✚

remote controls and one Security✚

Keyless

Entry System. If you purchase a new remote, or if you

wish to deactivate any remote, follow the instructions in

the Programming section.

Activate your opener with any of the following:

• The Hand-Held Remote Control: Hold the large push

button down until the door starts to move.

• The Wall-Mounted Door Control: Hold the push button

or bar down until the door starts to move.

• The Keyless Entry (see Accessories): If provided with

your garage door opener, it must be programmed

before use. See Programming.

When the opener is activated (with the safety reversing

sensor correctly installed and aligned):

1. If open, the door will close. If closed, it will open.

2. If closing, the door will reverse.

3. If opening, the door will stop.

4. If the door has been stopped in a partially open

position, it will close.

5. If obstructed while closing, the door will reverse. If the

obstruction interrupts the sensor beam, the opener

lights will blink for ﬁ ve seconds.

6. If obstructed while opening, the door will stop.

7. If fully open, the door will not close when the beam is

broken. The sensor has no effect in the opening cycle.

If the sensor is not installed, or is misaligned, the door

won’t close from a hand-held remote. However, you can

close the door with the door control, the Outside Keylock,

or Keyless Entry, if you activate them until down travel

is complete. If you release them too soon, the door will

reverse.

The opener lights will turn on under the following

conditions: when the opener is initially plugged in; when

power is restored after interruption; when the opener is

activated.

They will turn off automatically after 4-1/2 minutes or

provide constant light when the Light feature on the

Motion Detecting Door Control is activated. Bulb size is

A19. Bulb power is 100 watts maximum.

Security

✚

light feature: Lights will also turn on when

someone walks through the open garage door. With a

Motion Detecting Door Control, this feature may be turned

off as follows: With the opener lights off, press and hold

the light button for 10 seconds, until the light goes on,

then off again. To restore this feature, start with the opener

lights on, then press and hold the light button for 10

seconds until the light goes off, then on again.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comments to this Manuals

No comments

Chamberlain WD962KLD User Manual Page 32

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain WD962KLD