Chamberlain 248730 User Manual download pdf (Page 21)

Installation

STEP10 Install the door control

To prevent possible SERIOUS INJURY or DEATH from electrocution:

• Be sure power is NOT connected BEFORE installing door control.

• ConnectONLY to 24 VOLT low voltage wires.

To prevent possible SERIOUS INJURY or DEATH from a closing garage door:

• Install door control within sight of garage door, out of reach of children at a minimum height of 5

feet (1.5 m), and awayfrom ALL moving partsof door.

• NEVER permit children to operate or play with door control push buttons or remote control

transmitters.

• Activate door ONLY when it can be seen clearly,isproperly adjusted, and there are no

obstructions to door travel.

• ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross path

of closing garage door.

Install the door control within sight of the door at a minimum height of 5 feet (1.5 m) where small children

cannot reach,and away from the moving parts of the door. For gang box installations it is not necessary

to drill holes or install the drywall anchors.Use the existing holes in the gang box.

NOTE: Your product may look different than the illustrations.

HARDWARE

Scre

6ABx1-1/4" (2)

Drywall

Anchors

(2)

Screw

6-32x1"

(2)

Connect the door control wires:

1. Strip 7/16" (11 mm) of insulation from one end of bell wire and connectto the two screw

terminals on backof door control by color: white wire to WHT (1) and white/red wire to the RED

(2). If your garage is pre-wired for the door control, choose any two wires to connect, note

which wires are used so the correct wires are connected to the garage door opener in a later

step.

7/16" (11 mm) Top Mounting

Hole

Bottom Mounting

Hol

Top Mounting

Hole

Bottom Mounting

Hole

Install the Multi-Function Door Control:

1. Remove cover by gently prying at the top of the cover with a small flat head screwdriver.

2. Mark the location of the bottom-mounting hole and drill a 5/32 inch (4 mm) hole.

3. Install the bottom screw, allowing 1/8 inch (3 mm) to protrude from the wall.

4. Position the bottom hole of the door control over the screw and slide down into place.

5. Mark and drill the top hole.

6. Attach the top screw.

DRYWALL

GANG BOX

6-32x1"

6ABx1-1/4"

Drywall Anchor

Install the Door Control Button:

1. Mark and drill 5/32 inch (4 mm) hole(s).

2. Fasten door control button to wall with screws.

DRYWALL

GANG BOX

6-32x1"

6ABx1-1/4"

Drywall Anchor

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Comments to this Manuals

No comments

Chamberlain 248730 User Manual Page 21

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain 248730