Chamberlain 248730 User Manual download pdf (Page 33)

Operation

Using Your Garage Door Opener

Your Security+

opener and hand-held remote control have been factory-set to a matching code which

changes with each use, randomlyaccessing over 100 billion new codes. Your opener will operate with

up to eight Security+

remote controls and one Security+

KeylessEntrySystem. Ifyou purchase a new

remote, or if you wish to deactivate any remote, follow the instructions in the Programming section.

Activate your opener with any of the following:

The Hand-Held Remote Control: Hold the large push button down until the door startsto move.

The Wall-Mounted Door Control:Hold the push button or bar down until the door startsto

move.

The KeylessEntry(See Accessories): If provided with your garage door opener,it must be

programmed before use.See Programming.

When the opener is activated (with the safety reversing sensor correctly installed and aligned)

1. If open, the door will close. Ifclosed, it will open.

2. If closing, the door will reverse.

3. If opening, the door will stop.

4. If the door has been stopped in a partially open position, it will close.

5. If obstructed while closing, the door will reverse.If the obstruction interrupts the sensor beam,

the opener lightswill blink for five seconds.

6. If obstructed while opening, the door will stop.

7. If fully open, the door will not close when the beam is broken. The sensor has no effect in the

opening cycle.

If the sensor is not installed, or is misaligned, the door won’t close from a hand-held remote.However,

you can close the door with the Door Control, the Outside Keylock,or Keyless Entry, if you activate them

until down travel is complete. Ifyou release them too soon, the door will reverse.

The opener light will turn on under the following conditions:when the opener is initially plugged in; when

power is restored after interruption; when the opener is activated.

They will turn off automatically after 4-1/2 minutes. Bulb size is A19. Bulb power is 100 wattsmaximum.

Security+

light feature: Lights will also turn on when someone walks through the open garage door.

With a Multi-Function Door Control, this feature may be turned offas follows: With the opener lightsoff,

press and hold the light button for 10 seconds,until the light goes on, then off again. To restore this

feature, start with the opener lightson, then pressand hold the light button for 10 seconds until the light

goes off, then on again.

Using the Wall-Mounted Door Control

Door Control Button

Press the lighted push button to open or close the door. Press again to reverse the door during the

closing cycle or to stop the door while it’sopening.

The Multi-Function Door Control

Press the push bar/push button to open or close the door. Pressagain to reverse the door during the

closing cycle or to stop the door while it’sopening.

Light Feature

Press the Light button to turn the opener light on or off. Itwill not control the opener lightswhen the door

is in motion. Ifyou turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press

again to turn it offsooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2,or 3-1/2 minutes as

follows:

1. Press and hold the Lockbutton until the light blinks(about 10 seconds). A single blink

indicatesthat the timer is resetto 1-1/2 minutes.

2. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes.

3. Repeat again for a 3-1/2 minute interval,etc., up to a maximum of four blinks and 4-1/2

minutes.

Lock Feature

Designed to prevent operation of the door from handheld remote controls. However, the door will open

and close from the Door Control, the Outside Keylockand the Keyless Entry Accessories.

To activate, pressand hold the Lock button for 2 seconds.The push bar light will flash as long as the Lock

feature is on.

To turn off, pressand hold the Lockbutton again for 2 seconds.The push bar light will stop flashing. The

Lockfeature will also turn offwhenever the “Learn” button on the motor unit panel is activated.

Push Bar

Lock

Button

Light

Button

Push

Button

1 ... 32 33 34 ... 44

Comments to this Manuals

No comments

Chamberlain 248730 User Manual Page 33

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain 248730