Chamberlain 248730 User Manual download pdf (Page 38)

Operation

Programming

To Add, Reprogram or Change a Keyless Entry PIN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.

USING THE “LEARN” BUTTON

1. Press and release the “learn” button on motor unit.The learn indicator light will glow steadily

for 30 seconds.

2. Within 30 seconds,enter a four digit personal identification number (PIN) of your choice on the

keypad. Then press and hold the ENTER button.

3. Release the button when the motor unit lightsblink.It has learned the code. Iflight bulbs are

not installed, two clicks will be heard.

USING THE MULTI-FUNCTION DOOR CONTROL

1. Enter a four digit personal identification number (PIN) of your choice on the keypad. Then

press and hold ENTER.

2. While holding the ENTER button,press and hold the LIGHTbutton on the Multi-Function Door

Control. Continue holding the ENTER and LIGHT buttons while you press the push bar on the

Multi-Function Door Control (all three buttons are held).

3. Release buttons when the motor unit lightsblink. It has learned the code.If lightbulbs are not

installed, two clickswill be heard.

To change an existing, known PIN

If the existing PIN is known, it may be changed by one person without using a ladder.

1. Press the four buttons for the present PIN, then pressand hold the # button.

The opener light will blink twice. Release the # button.

2. Press the new 4-digit PIN you have chosen, then pressEnter.The motor unit lightswill blink

once when the PIN has been learned.

Testby pressing the new PIN, then pressEnter. The door should move.

To set a temporary PIN

You may authorize access by visitors or service people with a temporary 4-digit PIN.After a programmed

number of hours or number of accesses,this temporary PIN expires and will no longer open the door. It

can be used to close the door even after it has expired. To set a temporary PIN:

1. Press the four buttons for your personal entry PIN(not the last temporary PIN), then pressand

hold the * button.

The opener light will blink three times. Release the button.

2. Press the temporary 4-digit PINyou have chosen, then pressEnter.

The opener light will blink four times.

3. To setthe number of hours this temporary PIN will work,pressthe number of hours (up to

255), then press*.

1. To setthe number of times this temporary PIN will work, press the number of times (up to 255),

then press #.

The opener light will blink once when the temporary PINhas been learned.

Testby pressing the four buttons for the temporary PIN, then pressEnter. The door should move.If the

temporary

PINwas set to a certain number of openings,remember that the test has used up one opening. To clear

the temporary password, repeat steps 1-3, setting the number of hours or times to 0 in step 3.

One Button Close: Opener can be closed by pressing only the ENTER button if the one button close

feature has been activated. This feature has been activated at the factory. To activate or deactivate this

feature press and hold buttons 1 and 9 for 10 seconds. The keypad will blink twice when the one button

close is active. The keypad will blink four times when one button close is deactivated.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Chamberlain 248730 User Manual Page 38

Comments to this Manuals

Related products and manuals for Kitchen Chamberlain 248730